10/2/06  

Dear Solutions Team,

Occasionally, a product or a piece of equipment comes to my attention to fill a special need this company has. Such a piece of equipment is the air-activated vacuum canister manufactured by your company.

We purchased the Spill-Pro about a month ago, and since that time have used it to clean up spills and leaks of hydraulic fluids, transmission and gear oil. It has proven to be both efficient and had saved our company about 50% in expense for absorbent products.

With Spill-Pro it now takes less than 5 minutes to transfer fluids from a 55 gallon drum to the hydraulic tanks on the different units. Additionally, when our new equipment is getting primed with new fluid, we use the Spill-Pro to pressurize the hydraulic fluid to the pump, which prevents any possible seizure.

We use our Spill-Pro in our yard, and because of its portability can also load it on a service truck and transport it to a job site to clean up a spill caused by a leaking cylinder or hose. I am also impressed by the fact that this machine is far safer to use around flammable fluids, due to the fact that it is air operated, and is it affordable to purchase.

On behalf of RJB Equipment and its management and employees, thank you for bringing the Spill-Pro to out attention.

Yours very truly,                                                                                 
Tadd E. Burns
Service Manager
RJB Equipment, Inc.

Date: Fri, 24 Feb 2006 10:48

Hi Clay and everyone,

Performing Depot Level maintenance out here at Tinker Air Force base, Oklahoma City, Oklahoma, the Spill Pro has been a valuable tool , in our daily usage, to perform our tasks. One of the tasks it assists us in performing, is when we open up and mop out all the fuel tanks/bladders. Once the aircraft lands here for depot maintenance, we defuel the aircraft of what the Aircraft landed here with.

Usually after this operation is performed, there is usually around 100 to 300 gallons of fuel , still inside the tanks. In order for the LEL/O2 level to be within proper tech datalimits, for this aircraft to go inside any of our hangars, we have to send a person in the tanks and suck out all the loose fuel and break the fine lines to try and get all the fuel out of the Aircraft. Prior to us receiving the Spill pro, we were using a sucker barrel which is a 100 gallon tank on a trailer.

It would be hooked up to 2 High Volume Low Air units. Working the KC-135 from wing tip to wing tip, would require 2 to 4 people to maneuver this unit around. During the winter months, it would be a hair raising deal to move this unit, the air hoses and vacuum hose, over the ice and snow. With the Spill pro, one person can perform this task safely without worry. The unit is light weight and ice and snow hold no problem to moving this unit around, by one person.Another task we use this unit for, is when we change components on the flightline.

Changing fuel filters and hydraulic engine driven generators, they are always fluid in the lines we have to remove to change the component out. With the Spill pro there, we can easily suck up all the fluid that runs out on the ramp.

With this unit there, we cut down the cost of buying absorbent material to absorb the fluid , which in turn, cuts down on the hazard of F.O.D. on the ramp. With the Oklahoma winds, this material would never be where you wanted and needed it to be.

Another task we use this for is when we Purge the Aircraft engines for storage , before we remove the engines off the aircraft. When we use the purging fluid to cycle thru the engines, the Spill pro is always there, to mop up any fluid that comes out during the purge. The list goes on and on and daily, we are finding new ways of using this jewel, to our benefit.

The amazing thing, is with several dozen people using this unit, it is a no brainer in operation. It is simple and easy to use, and the unit has hardly no moving parts to wear out or break down.

On the average , we have been using ours for around 18 hours a day sometimes 7 days a week, and it works like it did on day 1. being a Work leader out here at Tinker and having 30 plus years of doing this job, we have finally found a unit that works to our advantage and lives up to it's name.

I know years ago, people were reading in the paper about the government buying $700.00 hammers and $2,000.00 latrines, but they would be proud in the government today, hearing how little we paid for a unit that works like this unit does.

Tom Rakowski, Tinker AFB

                                                                                          

Hi guys,
It took a lot of convincing for me to even try the spill pro due to the cost, but after using the spill pro I would not use anything else. It has saved us in more ways than one. The fact that we can evacuate a system instead of draining it and having to drain the drain pan has saved us on man-hours alone, not to mention that we have in floor drains that drain to a water separator then to the soil and it has to be tested quarterly . If we fail a test it would cost us another $500.00 for a re-test, not to mention the expense of chemical to get our discharge to an acceptable level. The savings of possible Worker Comp claims due to falls or slips on oil spills, oil dry, man-hours, and DEQ/EPA tests has paid for this product in one month. I am now a believer and plan to put this product in all of our shops.
This product is a Safety Manager’s dream. Thanks Spill Pro.

Kent Harrison                                                                                      
Safety/Risk Manager & Trainer
Louisiana Lift & Equipment, Inc.

From: This e-mail address is being protected from spambots. You need JavaScript enabled to view it                                            
To: greatgreensolutions
Subject: FW: RE: Letter
Date: Wed, 28 Dec 2005 16:48:58 -0700

To whom it may concern,

We recently purchased the Spillpro units for our shop to eliminate the need for floor dry absorbent. Do to the high importance of contamination in Caterpillar Dealer repair facility we found the Spillpro saved us money and gave us no reason to continue to use the absorbent.

It is now being used in some of our other facilities and during our recent inspection from Caterpillar it helped us receive the highest score possible.

Regards

Good Afternoon,

My name is Tom Rakowski out here at Tinker Air Force Base, Oklahoma City, Oklahoma. Clay Roy just performed a demo on your product and I just wanted to tell you, that this gentleman was perfect. Your product is something that we have been searching for, and Clay talked to us, on terms that we can understand.

He wasn't dressed in a suit and tie and afraid of getting a bit dirty. He is very knowledgeable about the product he represents and answered all the questions that everyone had for him. I can only speak for the -135 Aircraft Division, but I can say that he opened the door for your product to be used and sold out here on the Air Force Base.

As soon as our Safety office checks it out and see's just what a great asset this machine will be for us, I am sure that they will be talking to the other weapon systems like B-1, E-3 , B -52 and the Navy Squadron, to invest in this product.

Clay is a valuable asset to your company and we just wanted to extend a "THANK YOU" to him and the company he represents. I am sure that with the next few weeks, you will be hearing from our purchasing personal, and they will be putting in their order to purchase your product.

Have a wonderful week end and keep up the fine job. Thank You Clay and
Great Green Solutions.

Tom E. Rakowski

739-5846

5 out of 4 people cannot do fractions(Forrest Gump)

76 AMXG / MXAATA

To: The greatgreensolutions Team
RE: Free trial of your spillpro 13 gallon unit

Greetings,

Our staff found the Spillpro unit easy to use and had excellent results for cleanup. We found that is was faster and more cost-effective to use this machine versus using a plain mop or even worse using absorbent floor sweep.

Adam Hegewald
General Manager
Hydraulics, Inc.

June 30, 2006

The Spillpro
greatgreensolutions

Ref. 25 Gallon Spillpro unit

Dear Clay & Doug ;

I wanted to take a minute to thank you for contacting me about your Spillpro units. It does everything you said it would do and performs exactly like the demo tape on your web site www.GreatGreenSolutions.com.

After reviewing the demo tape, I was still a little hesitant that the unit would perform as shown in the video but after recfeiving the unit and using it in our shop it does everything you said it would do and as shown in the video. After we move into our new shop we will be purchasing more units.

Thank you,

Tom Kennedy
Service Manager

To: This e-mail address is being protected from spambots. You need JavaScript enabled to view it                                                        
Subject: FW: RE: Testimonial for meeting
Date: Fri, 24 Mar 2006 14:38:08 -0500

We find the "Spillpro" to be a very handy and valuable tool in our shop. Hydraulic messes are very often, unavoidable. It very quickly vacuums up the majority of spilled oils.

We still use floor dry absorbents, but the amount we use has probably been reduced by 70%. Although its promamry "job" is sucking up oil off the floor, we've also found it handy, with the help of homemade adapters, in avoiding spills by using it as a vacuum source.

When you have to remove a HYD. device that you know will cause a steady leak for the duration of the repair, create a vacuum in the thop of the hydraulic tank first, then it doesn't leak at all. We also have many pieces of equipment with very slow draining hoses out of the engine oil pans.

By using suction, an oil drain that normally runs 15 minutes can be done in less than 1 minute. As a last note, it has reduced the time absorbents have to be oh the floor drastically.                      

____________________________________________________________________________________________________________

July 14, 2006                                              

Spillpro is a great product!!!

Our center purchased the first Spillpro Unit 2 years ago. We were so thrilled with the unit, we purchased a second one less than a year later.

All of the employees in our shop use it, and have never had any problems with them.

Aamco Transmissions would highly recommend this product to other shops. We have found that it pays for itself in saving time of the employee and the cost of cleaning materials.

Scott H. Harvery/Owner
Aamco Transmissions
Las Vegas, Nevada
_____________________________________________________________________________________________________________________________________________

                                                                         
Spill Pro has revolutionized the way we clean our shop. This does exactly what it was designed to do. No more waiting for the cat litter to do its thing.

With this baby, the spill is cleaned up faster then an armadillo can cross the road. When we clean up a spill, it's as if there never was a mess at all! It's awesome! Way to go guys!

David Tillotson
PCM 318 Sunbelt Rentals Inc.
Arlington, TX                
      _______________________________________________________________________________________________________________________________________________                                                                        
 

                                                                                                               
To whom it may concern,

We have been using Spillpro for over a year now and have found it to be an extremely efficient and cost effective alternative for cleaning & spills.

We also use Spillpro to transfer fluids from drain pans to 55 gallon drums as well as pumping out fuel tanks. This tool is used on a daily basis and has freed up more of our technician's time so they can get pur customer's vehicles out faster.

We take pride in the cleanliness of our shop and thank Spillpro for assistng us with this.

Sincerely,
Brian Eki
Service Manager
Pacific Power Products

      _______________________________________________________________________________________________________________________________________________                                                                                                               

To Whom It May Concern,

My name is Mario Villalba from United Rentals in Fullerton. A very nice sales person by the name of Jessica called me one afternoon and said she had a piece of equipment that would make my oil spills disappear well we talked and she convinced me that I could rely on this in my day to day business she was not lying.

This piece of equipment is great, my shop has never been cleaner and I credit it to the machine but more to Jessica for introducing me to a great product.

From,
Mario Villalba

 ____________________________________________________________________________________________________________________________________________                                                                                                                                

 January 10, 2007
The greatgreensolutions guys

I was happy to have one of your Spill-Pro units demonstrated at our shop in Ridgefield Washington. I was impressed with how easy it is to use and I am looking foward to not having to continually purchase other products for cleaning up spills; and having to dispose on those products.

This is a quick and easy way for our technicians to clean up after themselves when a spill occurs. Since the purchase was made in Ridgefiels we have added more units in other branches as well.

Sincerely,
Steve Hidy
Branch Manager
Pacific Power Products
Hawaii

_____________________________________________________________________________________________________________________________________________
                                                                         
                                                                                                                                                                             
  

The unit has performed well for us so far. In addition to floor cleanups, they have used it for pulling transmission and hydraulic oils, as well as fluids directly from drain pans.

The unit works great when using the larger attachments, but the guys say that it is a little slow when pulling through the smaller tube.

We knew that going in though, and I'm not sure there is a resolution to the problem. We are pleased with it none the less.

Guy R. Sundvik
Assistant Field Division Manager                                                                             
City of Pasco, WA
Phone: (509) 545-3463
Fax: (509) 545-3466
E-mail: This e-mail address is being protected from spambots. You need JavaScript enabled to view it